Publicité
Les langues disponibles
Les langues disponibles
4.4- Switch On/Off
To operate product: press on trigger switch (4).
To stop product: release the trigger switch (4).
Note: the switch cannot be activated wen the selector (3) is set in
middle position.
Note: a light pressure on the ON/OFF trigger switch (4) results in
low speed, allowing drilling to begin in a smooth, controlled manner.
Further pressure on the switch results in an increase in speed.
The rotational speed to be used depends upon the material being
worked upon.
4.5- Changing to Forward or Reverse mode (Fig.1)
To change the rotation, press on the Forward/Reverse selector (3).
Note: do not abruptly change rotating direction when machine is operating.
4.6- Inserting and removing an accessory
Ensure to remove the battery before proceeding with any intervention.
4.6.1- Inserting an accessory
Note1: Use only a clean work tool. Before insertion into the
chuck, lubricate the shaft of the accessory lightly with machine
grease.
Note2: the word accessory used in this paragraph refers to the
bits, chisels and keyless chuck
1. Pull locking sleeve backwards and hold it.
2. Insert the accessory into the chuck as inside as possible, and
then release locking sleeve.
3. Ensure that accessory is securely locked in by firmly pulling
on it.
4.6.2- Removing an accessory
1. To remove the accessory, pull locking sleeve backwards and
hold it.
2. Remove the accessory and release locking sleeve.
3. Clean the accessory and rub it over with a small amount of
machine grease
4.7- Selector Drill, Drill/Hammer and Hammer
Place the selector on desired position:
: Drill position
: Drill / Hammer position
: Hammer position
Page 25 / 43
Publicité
