Publicité
Les langues disponibles
Les langues disponibles
Cold weather operation
For cold weather operation, near and below freezing, the moisture in the air line may freeze and prevent tool
operation. We recommend the use of a winter formula air tool lubricant.
Caution: Do not store tools in a cold environment to prevent frost or ice formation on the tool's operating
valves and mechanisms that could cause tool failure.
Note: Some commercial air line drying liquids are harmful to O-rings and seals – do not use these low
temperature air dryers without checking compatibility.
Loading the Flooring Stapler
To prevent accidental injuries:
• Always wear ANSI approved eye protection
• Never place a hand or any other part of the body in nail discharge area of the tool while the air supply is
connected
• Never point the tool at other people
• Never pull the trigger unless nose is directed at the work
• Always handle the tool with care
• Do not pull the trigger or depress the trip mechanism while loading the tool
Staple loading:
Pull cover open. Insert stick of staples. Push cover forward until the detent pin snaps into place, locking the
cover. The tool is now ready to operate.
Tool Operation
• Flooring stapler is actuated (fired) by hitting the cap firmly with a mallet (not included.)
• Always wear ANSI approved eye protection
• Never use this tool in a manner that could cause a fastener to be directed toward the user or others in the
work area
• Do not use the tool as a hammer to position flooring strips, this could damage the stapler. Use the mallet for
this purpose instead.
• Always carry the tool by the handle. Never carry the tool by the air hose.
• Do not alter or modify this tool from the original design or function
• Always be aware that misuse and improper handling of this tool can cause injury to yourself and others
• Never clamp or tape the trigger or contact trip in an actuated position
• Never leave a tool unattended with the air hose attached
• Do not operate this tool if it does not contain a legible warning label
• Do not continue to use a tool that leaks air or does not function
properly. Notify your nearest Princess Auto Location if your tool
continues to experience functional problems.
Publicité
