Publicité
Les langues disponibles
Les langues disponibles
Please read this manual before operating, and understand the warnings and cautions. The installation, operation
and maintenance procedures should be read carefully, and the manual kept for reference. Note: additional
safety measures may be required as a result of your particular application of the tool.
Safety Instructions
Eye protection that conforms to ANSI specifications and provides protection against flying particles both from
the FRONT and SIDE should ALWAYS be worn by the operator and others in the work area when loading,
operating or servicing this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury. Note: non-side shielded spectacles and face shields alone do not provide
adequate protection.
Caution: Additional safety precautions will be required in some environments. For example, the work area may
include exposure to a noise level which can lead to hearing damage. The employer and user must
ensure that any necessary hearing protection is provided and used by the operator and others in the
work area. Some environments will require the use of ANSI approved head protection.
Air supply and connections
Do not use oxygen, combustible gases or bottled gasses as a power source for this tool, as the tool could
explode, causing personal injury.
Do not use supply sources which can potentially exceed 120 PSI, as tool could burst, causing personal injury.
The connector on the tool must not hold pressure when air supply is disconnected. If a wrong fitting is used,
the tool can remain charged with air after disconnecting, and can drive a fastener even after the air is
disconnected, possibly causing injury.
Always disconnect air supply: before making adjustments, when servicing the tool, when clearing a jam, when
the tool is not in use, and when moving to a different work area, as accidental actuation may occur, possibly
causing injury.
Loading Tool
When loading tool: never place a hand or any part of the body in fastener discharge area of tool, never point
tool at anyone. Do not pull the trigger or depress the trip as an accidental actuation may occur, causing injury.
Operation
Always handle the tool with care. Never pull the trigger unless nose is directed toward the work, keep others a
safe distance from the tool while tool is in operation, as accidental actuation may occur, possibly causing
injury.
The operator must not hold the trigger pulled on contact arm tools except during fastening operation as serious
injury could result if the trip accidentally contacted someone or something, causing the tool to fire.
Keep hands and body away from the discharge area of the tool. A contact arm tool may bounce from the recoil
of driving a fastener and an unwanted second fastener may be driven, possibly causing injury.
Check operation of the contact arm mechanism frequently. Do not use the tool if the arm is not working
correctly as accidental driving of a fastener may result. Do not interfere with the proper operation of the
contact arm mechanism.
Do not drive fasteners on top of other fasteners or with the tool at an overly steep angle, as this may cause
deflection of fasteners which could cause injury.
Do not drive fasteners close to the edge of the work piece as the wood may split, allowing the fastener to be
deflected, possibly causing injury.
Maintenance
When working on air tools, note the warnings in this manual and use extra care when evaluating problem tools.
Publicité
