Belkin F5U261 Manuel D'utilisation page 9

P74102-em-F5U261-man-9-02.qxd
INSTALLATION
4. Plug the provided USB cable into the USB connector on
the rear of the Hub. (See Fig. 4). Plug the other end of
the USB cable into an available port on a Hi-Speed USB
2.0 host adapter card.
Fig. 4
Note A: The Hub must be connected to a USB
2.0-compliant host in order to function in high-speed
mode (480Mbps data rate). If the Hub is connected to a
USB 1.1-compliant host, it will operate only in low- or
full-speed mode (1.5Mbps or 12Mbps).
5. Replace your computer's cover and turn the power on.
6. Your Windows operating system will now detect the Hub
and install the required drivers. (The Windows "Install
New Hardware Wizard" may prompt you to provide your
Windows Installation CD to complete the driver
installation process.)
9/24/02 10:04 AM
(CONTINUED)
5
Page 5
En