Publicité
Les langues disponibles
Les langues disponibles
Optional Infrared Sear Burner
How to Replace Conventional Burner with Infrared Sear Burner (A video for installing the infrared sear burner is
located on the blaze website to assist with the below instructions,
To install the optional infrared burner, begin by removing the far left cooking grid, flame stabilizing grid and
1.
zone divider.
Remove conventional burner by first removing the cotter pin that holds it in place
2.
removed prior to installation)
outside of the grill body. With the cotter pin removed, remove the conventional burner.
Place the infrared burner in place, leaving off the flame tamer. Ensure the burner is seated appropriately around
3.
the valve so that gas flows into the burner.
Replace the heat zone divider and cooking grid. Do not use this burner with the flamer tamer
4.
reinstalled above the burner.
Note: It is critical that the end of the infrared burner is installed appropriately onto the gas valve to ensure gas flows safely
into the burner. For additional information, contact us at 866-976-9510 or go to Blazegrills.com.
Preheating the Infrared Burner
Always preheat the entire appliance before cooking. If the appliance is already hot from cooking, you should still preheat
the infrared burner for 3 minutes with lid open. Never place food over the burner until it is fully preheated to avoid clogging
the tiny ports and damaging the burner from grease drippings and food particles.
Infrared Burner Cleaning
To keep your infrared burner operating at maximum performance after each use, turn it on HIGH for 5-7 minutes with the
hood open. This allows any food particles or grease drippings to burn away. Once your appliance has cooled completely,
use a soft brush or vacuum to remove any ash accumulation on the burner if necessary.
www.blazegrills.com
, located on the bottom rear of the burner and accessible from the rear
Blaze Instructional Book
Page | 32
)
(unless they were
Publicité
