Publicité
Les langues disponibles
Les langues disponibles
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
MENU
DMX Address – Set the DMX address
Press MENU, press the UP or DOWN button until "Addr" is displayed, press ENTER.
"Axxx" will now be displayed, ("xxx" represents the displayed address). Press the UP or
DOWN button to find the desired address. Press ENTER to confirm
Auto mode – This menu will let you select the desired auto mode.
Press MENU, press the UP or DOWN button until "Auto" is displayed, press ENTER.
There are 3 auto modes, press the UP or DOWN button to select the desired mode, press
ENTER to confirm.
Channel mode – Select the desired channel mode
Press MENU, press the UP or DOWN button until "Chnd" is displayed, press ENTER
"X Ch" will now be displayed, ("X" represents the displayed channel mode). Press the UP or DOWN button to find the desired
channel mode. Press ENTER to confirm.
Color mode – Select the desired color mode
Press MENU, press the UP or DOWN button until "CoLo" is displayed, press ENTER.
"Colx" or ATF will now be displayed, ("X" represents a number between 1 – 9). Press the UP or DOWN button to find the desired
color mode. Press ENTER to confirm.
ATF: Make your own color by mixing and adjusting the Red, Blue and Green color.
Sound mode – In this mode you can select your desired sound active mode
Press MENU, press the UP or DOWN button until "soun" is displayed, press ENTER.
Select the desired sound mode and press ENTER
Slave mode – In this mode the unit functions as a slave
Press MENU, press the UP or DOWN button until "Slav" is displayed, press ENTER.
"Sla" will now be displayed, Slave mode is confirmed. The unit will now act as a slave in Auto, sound and chase mode.
Version – Will display the software version of the unit.
Press MENU, press the UP or DOWN button until "ver" is displayed, press ENTER.
The software version of the unit will be displayed. Press MENU to leave this function
4
Publicité
