Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Storing Accessories
The Pressure Washer is equipped with
places to store your accessories as shown
(see diagram on page 8).
1. Place Spray Gun into Gun Holder
2. Place nozzles in the top panel.
3. Coil and tie Pressure Hose and hang on
the hose hanger.
Pump Preparation
1. Disconnect the high-pressure hose and
the water supply hose from the pump.
2. Pull starter rope handle several times to
expel water from the pump.
NOTICE: It is normal to see water exit
both inlet and outlet of pump during this
exercise.
CAUTION: Cold storage location
• If product will be exposed to temperatures below 32° F / 0° C during storage, the
use of a pump protection product (not included) is required. Use the pump protection
product per the pump protection manufacturer's instructions.
• Failure to prepare the pump for exposure to cold temperature will cause damage to
the pump and void your warranty.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
Storage Area
Cover and store in a dry, level, well-
ventilated area out of reach of children.
Storage area should also be away from
ignition sources, such water heaters,
clothes dryers and furnaces.
Preparation for Use After Storage
1. Slowly pull the starter cord a few times
to clean oil from the cylinder or to eject
any pump protector from the pump which
may have been added prior to storage.
2. Remove the spark plug from the cylinder.
Wipe oil from the spark plug and return it
to the cylinder and re-tighten.
3. Reconnect the spark plug wire.
4. Refuel engine per earlier instructions in
this manual.
24
Publicité
