iPower PWF3200SH Manuel Du Propriétaire page 13

SET UP
6. Attach the nozzle to the wand by
pulling back the quick connect collar
and pushing the nozzle onto the end of
the wand. Make sure the quick connect
collar locks the nozzle in place.
See Figure G.
General Information
Fuel
Oil
Water
Pressure
Adjustment
Figure G
Nozzle
Quick connect
collar
Wand
Use fresh high-quality unleaded gasoline (minimum 87 octane),
containing up to 10% ethanol.
Do not use fuel with high ethanol content; E15 or E85.
Engine oil: Use only SAE 1 0W-30, 0.6 Quart non-detergent oil
(supplied).
Pump Oil: The pump was lubricated and sealed at the factory, and is
maintenance free for the life of the product, under normal operation. Do
not attempt to change or add oil to the pump. If the pump is leaking oil,
please call our customer service department at 1-855-888-3598.
Use only cold water.
Do not operate pressure washer with clogged or missing water inlet filter
screen.
Do not operate pressure washer without adequate water supply.
Pressure setting is pre-set at factory.
For lowering pressure, refer to "Pressure Adjustment" on Page 18.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
7. Connect the water supply hose to the
water inlet connection on the Pump and
tighten the Inlet fitting firmly by hand.
See Figure H.
The water source must be able to
provide a minimum of five gallons of
clean, cold water per minute at 20PSI.
Only use a 5/8" inner diameter, or larger
hose that is rated to meet this capacity.
11
Figure H