Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Pressure Washer Operation
WARNING: Eye protection / Fluid Injection hazard
attached accessories. The high-pressure stream of water that this equipment produces
can cut through skin and its underlying tissues, leading to possible amputation. The
spray gun traps high water pressure, even when the motor is stopped and water source
is disconnected, which can cause injury.
• Do not direct spray from the Pressure Washer at any persons or animals.
• Keep children and pets away from the work area.
• Keep work area clean of loose rocks, glass and debris.
• The high pressure water stream could cause serious injury.
WARNING: Asphyxiation Hazard
Use the Pressure Washer only outside in a fully ventilated area.
• Operate this product ONLY outside far away from windows, doors and vents.
• DO NOT run this product inside homes, garages, basements, crawlspaces, or sheds.
• ALWAYS place this product downwind and point the engine exhaust away from
occupied spaces.
•
If you start to feel sick, dizzy, or weak while using this product, shut it off and get to
fresh air RIGHT AWAY. See a doctor, as you may have carbon monoxide poisoning.
1. Select the right nozzle for the job
Your product is supplied with a selection
of quick connect nozzle tips. The nozzles
are sized specifically to give you maximum
pressure at all times. Each nozzle is
marked and rated in degrees of fan. They
are also color coded (see chart on opposite
page). The higher the number of the fan
degree, the wider the fan pattern is. The
tighter the spray fan the more impact on
the surface, which is good for cleaning
NOTICE: Not all models come with all nozzles described in this section. Use only the
information pertaining to the nozzles supplied with your product.
(Nozzle selection Chart)
ALWAYS wear approved safety glasses when operating Pressure
Washers. Spray can splash back or propel objects, including incorrectly
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
tough jobs. The wider the spray fan, the
more spread out the impact on the surface,
so they are better for easy jobs, or soft
surfaces. Finding the correct nozzle for the
job at hand make take some experimenting.
Always start with the widest fan degree and
continue to the lower degree fans until the
best work result is achieved. Always test
the nozzle on an area that is not noticeable.
16
Publicité
