Publicité
Les langues disponibles
Les langues disponibles
CHANGING A LED SPOT
When a LED spot of the cooker hood is broken, you can replace it yourself. Follow these steps:
• Unplug the appliance or remove the connector fuse.
• Remove the grease filters and push the complete spot from the inside downwards - figure 1.
• Unplug the broken LED from the transformer - figure 2. Replace the complete LED with a matching type (2.0 W, LED
L27A).
• Plug the new LED in the transformer and push the complete spot back in the housing of the cooker hood.
• Replace the grease filters and plug the appliance in.
1
2
6
troubleshooting
What to do in case of a malfunction? In most cases, you will be able to correct these faults easily yourself. Please check the
solutions below before contacting the Inventum service department.
The motor is not running
• Is it plugged in correctly?
• Is there a power outage?
• Check the electrical installation.
The performance of the cooker hood is not correct and makes more noise.
• Is the diameter of the exhaust-air pipe correct?
• Is the duct blocked?
• The diameter of the duct must be 150 mm. A smaller diameter can negatively influence the suction of the motor.
• Are the grease filters clean?
• Are the carbon filters not replaced within the last 6 months? Replace the carbon filters.
• Is there enough air supply to replace the extracted air?
20
•
English
Publicité
