Microgard 4079 Consignes D'installation

Difficulty Rating
Note de difficulté
Calificación de dificultad
Application: Application: Aplicación:
Ford C-Max, Escape, Focus, Transit | Lincoln MKC
Fig 1
Fig 4
Location of cabin filter: The filter is located under the glove box on the right side
of the middle console.
Tools: 7/64 Allen Wrench
To remove existing filter:
1. There is a cover under the glove box that must be removed to access the
filter housing.
2. Squeeze the sides of the two screw clips to remove them from the cover. (Fig 1)
3. Pull down on the panel to remove it from the vehicle.
4. Using a 7/64 Allen Wrench remove the screw that secures the bottom of the
housing cover to the housing. (Fig 2)
5. Push in on the two side clips to remove the filter housing cover. (Fig 3)
6. Pull out on the old filter to remove it from the housing. (Fig 4)
7. Pinch the middle of the new filter to maneuver it into the housing. (Fig 5)
8. Insert the new filter into the housing with it's airflow indicator arrow pointing
towards the cabin and make sure it expands back to fill the housing.
9. Clip the cover back onto the housing and make sure the tabs re-engage.
10. Reinstall the 7/64 screw that secures the housing cover to the housing.
11. Reinstall the bottom panel and attach the screw clips back onto the screws.
Fig 2
Fig 5
Installation Bulletin
Bulletin d'installation
Boletín de Instalación
Fig 3
4079
04-2014