Microgard 3964 Guide Rapide

Difficulty Rating
Note de difficulté
Calificación de dificultad
Application: Application: Aplicación:
Lexus IS300, RX300 | Toyota Highlander
Installation Bulletin
Bulletin d'installation
Boletín de Instalación
Location of cabin filter:
On the passenger side of the vehicle behind the glove
compartment behind the cabin filter access panel.
Tools:
Unknown or not required.
To remove existing filter:
1. Open glove compartment and carefully press in on each
side of the glove compartment allowing the stops to pull away
and allow the glove compartment to swing down.
2. Locate and remove the cabin filter door by pulling
downward and towards you.
3. Pull out dirty filter and housing.
4. Remove dirty filter from housing by releasing the tabs to
secure the filter to the housing.
5. Replace clean filter in housing. Remember to secure filter
to housing with tabs.
6. Complete installation by reversing procedure.
3964
09-2011