Microgard 3673 Guide Rapide

Difficulty Rating
Note de difficulté
Calificación de dificultad
Application: Application: Aplicación:
Hyundai Accent, Gensis, Tucson, Veloster | Kia Forte, Rio, Rondo, Sportage
1.
3.
Location of cabin filter:
Behind glove compartment, behind cabin filter access door on the
passenger side of the vehicle
To remove existing filter:
1. Open glove compartment. (Fig 1)
2. Locate and unclip the glove compartment hydraulic retaining
device from the right hand side of the glove compartment. (Fig 2)
3. Push in on both sides of the glove compartment door until the
stop pins are clear of the glove compartment frame which allows the
glove compartment door to swing completely downward. (Fig 3)
4. Locate the cabin filter housing and remove by pulling on the tabs
on either side of the housing and remove. (Fig 4)
5. Remove the dirty cabin filter from the housing. (Fig 5)
6. Place the new cabin filter in the housing.
7. Complete installation by reversing steps 1-4.
Important: re-install the hydraulic retaining device to the right
side of the glove compartment.
2.
4.
Installation Bulletin
Bulletin d'installation
Boletín de Instalación
5.
3673
03-2016