Publicité
Les langues disponibles
Les langues disponibles
6. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are specially designed to protect the exterior base of the custom hood. To order, refer to the table below to
find the right liner model number for your insert and width of custom hood. To view specific model information, including
depths for each liner models, visit www.broan.com or contact Technical Support (phone number listed on front cover).
To install, see instruction packed with custom hood liner.
The liner must be installed before the insert.
NOTE : On some liners models, front liner piece may overlap front insert flange. If so, remove the front liner piece,
assemble insert, and reassemble front liner piece.
LINER MODEL
INSERT MODEL
RML3336S
RMIP33
RML3342S
RMIP33
RML4548S
RMIP45
RML4554S
RMIP45
RML4560S
RMIP45
7. INSTALL THE RMIPWC REMOTE CONTROL (OPTIONAL)
The electrical connection for the remote control is located in
front of the insert. Perform this connection before the insert
installation. For installation details, see installation instructions
included with the RMIPWC remote control.
8. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the cabinet, using
the dimensions shown beside.
INSERT MODEL NUMBER
RMIP33
RMIP45
NOTES : 1. The notch shown in the inset must be cut only if the
RMIPWC optional remote control will be installed.
2. The recommended distance from the back to the
rearmost cutout edge is 2¼'' minimum.
9. INSTALL BLOWER (INTERIOR OR EXTERIOR BLOWER)
INTERIOR BLOWER:
Follow all subsequent steps of this manual.
EXTERIOR BLOWER: Refer to instructions packed with exterior blower and follow steps 13, 14, 16, 17, 19 and up
of this manual.
CUSTOM HOOD
NOMINAL WIDTH
36''
42''
48''
54''
60''
HA0038A
A
32½''
44½''
- 7 -
HL0044
17 1/16''
2 1/4''
A
min.
HD0084A
3 1/2''
16 3/8''
Publicité
