SNOWJOE sunjoe 24V-HT18-LTE Manuel De L'opérateur page 11

3. To turn the tool OFF, release the On/Off trigger (Fig. 4).
NOTE: Do not press the On/Off trigger until you are ready
to make a cut.
Cutting Procedures
m
WARNING!
Never cut near electric cords or power
lines. If the blade jams on any electrical cable, DO NOT
TOUCH THE BLADE. IT CAN CONDUCT ELECTRICITY
AND FATALLY SHOCK YOU! Instead, continue to hold the
hedge trimmer by the insulated rear handle, and lay it down
and away from you in a safe manner. Make sure that electrical
service to the damaged electrical cable is disconnected before
attempting to free the hedge trimmer blade.
Contact with the blade, other conductive parts of the hedge
trimmer, or live electric cords or power lines will result in death
by electrocution or serious injury.
m
WARNING!
Do not allow familiarity with this type of
product to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious injury.
m
WARNING!
Clear the area to be cut before each use.
Remove all objects such as cords, lights, wire, or loose string
which can become entangled in the cutting blade and create a
risk of electric shock and serious personal injury.
1. When trimming new growth, use a wide sweeping action
so that the stems are fed directly into the blade. Do not try
to cut branches that are thicker than 0.55 in. (1.4 cm) or
those that are obviously too large to feed into the blade.
Use lopping shears, a hand saw, or a pruning saw to cut
out thick branches first. If a substantial cut is necessary,
cut a little at a time in several passes. Cut both sides of
the hedge first and then the top.
2. To perform a horizontal cut, hold the hedge trimmer with
the blade tilted 5-10 degrees to your cutting object; this
makes the operation easier and ensures a better cut
(Fig. 5).
5º – 10º
Fig. 5
3. To perform a vertical cut, start trimming at the bottom and
sweep up for even cutting. Swing the blades in an arc
towards the outsides of the hedge so that the cuttings are
swept on the ground (Fig. 6).
All manuals and user guides at all-guides.com
Cutting Tips
m
Always keep your dominant hand on the switch handle and
your non-dominant hand on the front. Never hold the tool by
the blade guard. Keep unit below waist level.
• A wide, sweeping motion, feeding the blade teeth through
• Begin at the bottom and sweep up.
• Do not force the hedge trimmer through heavy shrubbery.
• If blades do become jammed, stop the motor, allow the
• If desired, you can use a string to help cut your hedge
• Wear gloves when trimming thorny or prickly growth.
Care + Maintenance
m
or maintenance, remove the battery from the battery
compartment. Never touch the moving blades.
11
Fig. 6
WARNING!
Hold the tool firmly in both hands.
the twigs is most effective. A slight downward tilt of the
blade in the direction of the motion gives the best cut.
This can cause the blades to bind and slow down. If the
blades slow down, reduce the pace.
blades to stop, and remove the battery before attempting
to remove the obstruction.
level. Decide how high you want the hedge. Stretch a
piece of string along the hedge at the desired height.
Trim the hedge just above the guide line of string. Trim the
side of a hedge so that it will be slightly narrower at the
top. More of the hedge will be exposed when shaped this
way, and it will be more uniform.
When trimming new growth, use a wide sweeping action,
so that the stems are fed directly into the cutting blade.
Older growth will have thicker stems and will be trimmed
easiest by using a sawing movement.
ATTENTION!
Before performing any cleaning