Topaz CDL4S-13WPCS-U Instructions D'installation page 3

Item:
CDL4S-13WPCS-U CDL4S-RM-12WPCS-U
CDL6S-16WPCS-U CDL6S-RM-24WPCS-U
CDL8S-26WPCS-U CDL8S-RM-30WPCS-U
CDL10S-36WPCS-U
COMMERCIAL DOWNLIGHT POWER & COLOR SELECT
COMMERCIAL DOWNLIGHT POWER & COLOR SELECT
INSTALLATION INSTRUCTIONS
Internal Driver Installation:
Junction
Box
Figure 1
Junction
Box
Figure 2
Figure 3
Figure 4
©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark &
CDL-DWP
CDL-J-BOX
CDL-HB
CDL-EMBB8
INSTALLATION INSTRUCTIONS
1. Turn off electric power at the circuit breaker.
2. For New installations, use the Dimensions chart to mark and cut the
mounting hole to the correct size for the fixture being installed. For retrofit
application, remove the old fixture and/or fixture housing, then verify the
hole is the correct size for the fixture being installed. If not, trim to the
correct size.
3. Connect the safety cable to a secure structure such as a junction box (Sold
Separately). See Figure 1.
4. Connect the fixture wires to a junction box (Sold Separately) and make the
wiring connections according to the Wiring Diagram. See Figure 2.
5. Push up and hold the spring clips against the fixture. Gently guide into the
ceiling until the clips are in the hole. Tuck excess wire into the ceiling and be
sure not to pinch or crimp the wire. See Figure 3.
6. Let go of the clips and push the fixture up until it is flush with the ceiling.
See Figure 4.
800-666-2852 | TOPAZ-USA.COM
Trademark of Southwire Company, LLC.