Publicité
INSTALLATION ON 2-3/8" TENON WITH ADAPTOR (T2 MOUNTING)
2-3/8" X 4"
TENON
FOR ASYMMETRIC OPTICAL SYSTEMS
THE ARROW ON THE TOP COVER
INDICATES THE DIRECTION OF
STREET SIDE
STREET SIDE
CURBLINE
HOUSE SIDE
page
3
PPT
LUMINAIRE
4X 3/8-16 X 1/2" SET
SCREW. TORQUE TO
19 FT-LBS. (PROVIDED)
2-3/8" TENON ADAPTOR
WITH 6X 1/4-20 SET
SCREWS. TORQUE TO
10 FT-LBS. (ORDERED
SEPARATELY)
4.00" O.D. POLE
RECOMMENDED FOR
SMOOTH TRANSITION
WITH YOKE ASSEMBLY
1. INSTALL THE 2-3/8" TENON ADAPTOR (ORDERED AND
SHIPPED AS AN ACCESSORY) BY FITTING IT OVER THE 2-
3/8" TENON AND SECURING IT TO THE POLE USING THE SIX
1/4-20 SET SCREWS PROVIDED. TIGHTEN TO 10 FT-LBS.
2. THE PPT IS PROVIDED WITH LEVER LOCK CONNECTORS FOR
SIMPLE ELECTRICAL CONNECTIONS. MAKE SUPPLY WIRE
CONNECTIONS ACCORDING TO THE APPROPRIATE WIRING
TABLE BELOW. 0-10V LEADS ONLY APPLY TO CERTAIN
CONTROL OPTIONS. ADDITIONAL INFORMATION FOR
EMERGENCY BATTERY PACK WIRING AVAILABLE ON PAGES
BELOW.
3. PLACE SPLICES AND EXCESS WIRE IN TENON SHAFT. BE
SURE TO NOT PINCH WIRES BETWEEN THE TOP OF THE
TENON AND THE LUMINAIRE AS YOU CAREFULLY SET THE
PPT UPRIGHT ON THE POLE.
4. ORIENT THE YOKE ARMS TO THE DESIRED POSITION. FOR
LUMINAIRES WITH ASYMMETRIC OPTICAL SYSTEMS THE
CAST-IN ARROW ON THE TOP OF THE LUMINAIRE
INDICATES THE DIRECTION OF STREET SIDE (SEE
ILLUSTRATION BELOW).
5. USING THE FOUR 3/8-16 X 1/2" SET SCREWS PROVIDED
SECURE THE LUMINAIRE TO THE TENON ADAPTOR.
TIGHTEN TO 19 FT-LBS OF TORQUE.
443560819320-Rev E
Publicité
