Publicité
STANDARD INSTALLATION ON 3" TENON (T3 MOUNTING)
FOR ASYMMETRIC OPTICAL
SYSTEMS THE ARROW ON THE TOP
COVER INDICATES THE DIRECTION
OF STREET SIDE
STREET SIDE
CURBLINE
HOUSE SIDE
page
2
PPT
LUMINAIRE
4X 3/8-16 X 1/2"
SET SCREWS.
TORQUE TO 19 FT-
LBS. (PROVIDED)
3" X 4"
TENON
4.00" O.D. POLE
RECOMMENDED FOR
SMOOTH TRANSITION
WITH YOKE ASSEMBLY
1. THE PPT IS PROVIDED WITH LEVER LOCK
CONNECTORS FOR SIMPLE ELECTRICAL
CONNECTIONS. MAKE SUPPLY WIRE CONNECTIONS
ACCORDING TO THE APPROPRIATE WIRING TABLE
BELOW. 0-10V LEADS ONLY APPLY TO CERTAIN
CONTROL OPTIONS. ADDITIONAL INFORMATION FOR
EMERGENCY BATTERY PACK WIRING AVAILABLE ON
PAGES BELOW.
2. PLACE SPLICES AND EXCESS WIRE IN TENON SHAFT. BE
SURE TO NOT PINCH WIRES BETWEEN THE TOP OF
THE TENON AND THE LUMINAIRE AS YOU CAREFULLY
SET THE PPT UPRIGHT ON THE POLE.
3. ORIENT THE YOKE ARMS TO THE DESIRED POSITION.
FOR LUMINAIRES WITH ASYMMETRIC OPTICAL
SYSTEMS THE CAST-IN ARROW ON THE TOP OF THE
LUMINAIRE INDICATES THE DIRECTION OF STREET
SIDE (SEE ILLUSTRATION BELOW).
4. USING THE FOUR 3/8-16 X 1/2" SET SCREWS
PROVIDED SECURE THE LUMINAIRE TO THE POLE.
TIGHTEN TO 19 FT-LBS OF TORQUE.
443560819320-Rev E
Publicité
