Amica SHC 904 100 /1 W Notice D'utilisation page 91

OPERATION
 Set the oven function selector knob and
the temperature selector knob in off po-
sition.,
 Touch and hold
touch and hold < / > to mute the alarm,
the will be off and the display will show
the current time.
Cancel settings
Timer and Timed operation settings may be
cancelled at any time.
Cancel Timed operation settings:
 Simultaneously touch and hold the < / >
sensors.
Cancel timer settings:
 Touch the
MENU
en Timer,
 simultaneously touch the < / > sensors
Change the beep tone
You can change the beep tones as follows:
 Simultaneously touch the < / >, sensors
 Touch repeatedly to select the ton
MENU
(tone). The display will be flashing:
 Use the < / > sensors to select your pre-
ferred tone:
Use > to select the setting 1 to 3
Use < to select the setting 3 to 1
Adjust display brightness
You can adjust display brightness 1 to 9,
where 1 is the darkest and 9 is the brightest.
The brightness setting applies to an inactive
control panel, i.e. when no controls are
touched for 7 seconds.
You can adjust display brightness as follows:
 Simultaneously touch the < / > sensors,
 Touch repeatedly to select the bri
MENU
(brightness) setting — the settings can
be accessed in sequence ton (tone) and
bri (brightness).
or simultaneously
MENU
sensor to select the Kitch-
 Use the < / > sensors to select your pre-
ferred brightness:
Use > to select the setting 1 to 9
Use < to select the setting 9 to 1
Note:
The display is at its brightest setting when
active, i.e. a control was touched within the
last 7 seconds.
Night Mode
The display is dimmed during the night hours
22:00 — 06:00.
91