Publicité
Les langues disponibles
Les langues disponibles
finishing
EN
9.3
safety barrier, glass door and door trims removal / installation
WARNING
!
•
Glass may be hot. Do not touch glass until cooled.
•
If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
•
Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
•
Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with the appliance and must be
installed.
Before the glass door can be removed, the safety screen must be
removed. Lift the safety screen up and away from the appliance
(Fig. 1).
If not already installed, this appliance is shipped with a top and
bottom door trim packaged separately from the appliance.
Both trims MUST be installed (Fig. 2 - reverse this to remove).
Leave a hand on the glass door during entire door removal. The
glass door is secured to the firebox with 4 spring latches.
Pull the handles of the latches forward (door latch tool supplied
in manual baggie), then lift the latches out from the door frame to
release the top of the door. Next, pivot the door forward until the
top edge clears the front of the appliance. Carefully grip the sides
of the door lifting it off the appliance (Fig. 3).
Reverse these steps to re-install the safety screen and door.
Ensure safety screen is installed correctly.
note:
These spring latches make up the spring relief system
for the appliance. Ensure they open freely and close
sealed.
40
W415-2015 / B / 03.15.23
Fig. 2
47.1
B
A
Fig. 1
Fig. 3
Publicité
