Installation; Attention - ETNA EKR500CR Mode D'emploi

INSTALLATION

Attention!

The feeding pipes have to be rinsed thoroughly before the installation
of the mixer, so that no shavings, welding or hemp residual or other dirt
can be found in the pipes. Foreign bodies can enter the mixer through
the rinsed pipes or the general water plant and could damage the
washers/ring washers. Before the setting to work, unscrew the aerator
and rinse it very well.
40 MAX
• Before inserting the single lever group in the hole of the sink, make
sure that the base gasket is properly positioned in its seat and that
the flexible hoses are well tightened to the body of the tap. Place
the single lever group in the hole of the sink, orienting the spout
toward the sink tank.
Insert the fixing kit with the indicated sequence, and respectively:·
• the shaped gasket and flange in case the single lever group is
installed on a sink having thickness of 3-4 cm;
• the shaped gasket, the triangular plastic flange and the flange in
case of a stainless steel sink having thickness of 1-2 mm.
• Tighten well the tie rod or the threaded nut.
Models with handshower
Connect the flexible hose to the outlet pipe interposing the gasket.
Fix the lead counterweight to the flexible hose at a distance of approx.
400 mm from the connection to the outlet pipe.
Ø35
Ch. 11 mm
1-2 mm
GB 7