ETNA EKR500CR Mode D'emploi page 30

PRE-INSTALLATION INFORMATION
2 x Ø
2 x Ø
2 x Ø
2 x Ø
2 x Ø
Ø
Ø
Ø
Ø
Ø
NO!
NO!
NO!
NO!
NO!
GB 6
• Prolonged contact with any substance, even scarcely aggressive,
can cause external braid damage and subsequent flexible burst.
• Before bending the hose please consider a straight part of 2 times
the external diameter.
• Mantain minimum bend radius (DN= nominal internal diameter):
DN6 = Ø25mm
DN8 = Ø30mm
DN10 = Ø35mm
DN13 = Ø45mm
• Hand-tighten connectors with gasket seal (nuts) then apply 1/4 turn
using an appropriate wrench.
• Do not expose the hose to lateral stress nor overtight by any tool
(ex. during the installation of the faucet stud or the drain pop-up
lever).