Publicité
Les langues disponibles
Les langues disponibles
CLEANING
To maintain the appearance and increase the service life, clean your
induction range daily.
WARNING
Electrical Shock Hazard
Do not spray water or cleaning products. Liquid could contact
the electrical components and cause a short circuit or an
electrical shock.
CAUTION
Burn Hazard
Heating surface remains hot after equipment is turned off. Hot
surfaces and food can burn skin. Allow the hot surfaces to cool
before handling.
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pads to clean the equipment. These can damage
the finish. Use only a mild soap.
TROUBLESHOOTING
Problem
The display is flashing.
Message on the Display
F-01
F-02
F-05, F-06, F-07,
F10, F11, F24, F25
F-08
F16
F17, F18
F19, F20
F22
F23
HOT
Medium Power Countertop Induction Ranges with Knob Control Operator's Manual
Might be Caused By
There is not a pan on the range or the pan
is not induction-ready.
The range may have overheated because it
is too close to heat producing equipment.
The cookware may have been too hot when
it was placed onto the range.
There may be a problem with an internal
component.
The range may have overheated due to
insufficient airflow.
The sensor may have detected an empty
pan was on the range for too long.
There may be an issue with the incoming
power supply or there may have been a
power surge.
There may be an issue with the incoming
power supply quality.
The range is plugged into an outlet with the
wrong voltage.
A prolonged power surge.
The range is plugged into an outlet with the
wrong voltage.
A prolonged dip in the power supply
The user turned off the range. The cooking
surface is still hot.
1. Touch
to turn off the range. The display may show HOT until
the cooking surface cools.
2. Unplug the cord from the wall outlet.
3. Allow the equipment to cool.
4. Wipe the exterior with a clean damp cloth.
5. Thoroughly wipe off any soap residue.
NOTICE: Residue could corrode the surface of the unit.
Course of Action
Place a pan onto the range. Verify the pan is induction ready. See the
Cookware Requirements section in this manual.
Relocate the equipment away from heat producing equipment.
Contact Vollrath Technical Services if the problem persists.
Remove the cookware. Allow it to cool slightly before placing it on the
cooking surface. Contact Vollrath Technical Services if the problem
persists.
Try to clear the error by turning the range off, and then on. Contact
Vollrath Technical Services if the problem persists.
Make sure the equipment has adequate airflow. See the Clearance
Requirements section in this manual. Verify the air intake under the
equipment is not blocked. Contact Vollrath Technical Services if the
problem persists.
Remove the pan. Clear the error by turning the range off, and then on.
Place only pans with food in them onto the range.
Try plugging the range into an a electrical outlet that is on a different
circuit. Contact Vollrath Technical Services if the problem persists.
Try plugging the range into an a electrical outlet that is on a different
circuit. Contact an electrician to troubleshoot the electrical supply.
Make sure the power at the electrical outlet matches the rating tag on
the underside of the range.
Try to clear the error by unplugging, and then plugging in the range.
Resume operation. Contact Vollrath Technical Services if the problem
persists.
Make sure the power at the electrical outlet matches the rating tag on
the underside of the range.
Try to clear the error by unplugging, and then plugging in the range.
Resume operation. Contact Vollrath Technical Services if the problem
persists.
This is normal operation.
5
Publicité
