Axis T93C10 Manuel D'installation page 11

How to install the product
How to install the camera in the housing
1. Open the housing.
2. Remove the hardware pouch.
3. Loosen and remove the two rear screws that are securing the camera sled.
4. Remove the camera sled from the housing.
5. Attach the camera sled to the camera.
NO NO TICE NO TICE TICE
For cameras with large lenses, use the camera spacer between the camera and the camera
sled.
6. Connect the camera connector to the 24 V DC camera power wire in the housing. See
instructions in the camera's Installation Guide.
7. Slide the front of the camera sled, with the attached camera, into the two front fixed
screws to reinstall the camera sled into the housing.
8. Secure the camera sled with the two rear screws.
How to install the pan-tilt knuckle to the housing
1. Attach the screws to the knuckle.
2. Attach the knuckle to the housing.
3. Attach the screws.
Important
• For a downward position of the camera, make sure TILTING marked on the knuckle is
on the captive screw side of the housing.
• For an upward position of the camera, make sure TILTING marked on the knuckle is on the
hinge side of the housing.
AXIS T93C10 Outdoor Housing
11
EN