Husqvarna LB 442i Manuel D'utilisation page 16

• Obey the instructions for how
to change accessories. Only
use accessories from the
manufacturer.
• When not in operation, keep
the product, battery and
Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the handle
1. Remove the handle nut and the washer from the
plate on the upper handle.
2. Put the upper handle in position on top of the lower
handle.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
Husqvarna Fleet Services
Husqvarna Fleet Services
gives the operator an overview of all products that
are connected. On this product a Husqvarna Fleet
™
Services sensor can be installed. The Husqvarna Fleet
™
Services sensor collects product data and lets you
16
Read and understand the
Before you operate the
™
™
is a cloud solution that
battery charger apart in a dry,
indoor and locked area. Make
sure that children and persons
that are not approved cannot
get access to the product,
battery or battery charger.
Assembly
3. Attach the washer and the handle adjustment lever.
(Fig. 21)
4. Turn the handle to the side for a good operation
position when you operate the product near a wall.
(Fig. 22)
Operation
connect to the Husqvarna Fleet Services
Husqvarna Fleet Services
as operation time, servicing intervals and location of the
product.
For more information about Husqvarna Fleet Services
download the Husqvarna Fleet Services
to your Husqvarna representative.
To prepare the sensor (accessory)
1. Use the sensor key to open the lid of the sensor.
(Fig. 23)
2. Remove the sensor.
3. Connect the battery to the sensor. The LED light of
the sensor comes on. (Fig. 24)
4. Download the Husqvarna Fleet Services
5. Log on to the Husqvarna Fleet Services
6. Do a pairing operation. Refer to
operation between the app and the product on page
16
To do a pairing operation between the app
and the product
1. Log on to the Husqvarna Fleet Services
2. Select your product in the app.
3. Scan the code behind the sensor with your mobile
device to install the sensor in the app.
CAUTION:
Make sure that the wires
are not caught or become damaged.
™
system reports data such
To do a pairing
1520 - 005 - 21.08.2023
™
system. The
™
,
™
app or speak
™
app.
™
app.
™
app.