Publicité
Les langues disponibles
Les langues disponibles
Clean all rust protected surfaces with a mild solvent.
Install the tool caddies:
mount a tool caddy on each end of the lathe with two pan
head screws (Fig 5).
5.3 Mains connection
Mains connection and any extension cords used must comply
with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a
10A surge-proof fuse.
Only use power cords marked H07RN-F
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
5.4 Dust collection
Use a suitable dust collection and air filtration system to avoid
high dust concentrations in the air.
5.5 Starting operation
You can start the machine with the green ON-button (B, Fig
6).
The machine will stop when you push the red OFF-button (C).
Wait for the workpiece to come to a complete stop.
The spindle speeds are controlled by the position of the belt on
the pulleys (Fig 7).
Fig 5
Fig 6
6. Machine operation
6.1 Correct operating position
Always support the tool on the tool rest and guide with the
palm of your hand keeping your fingers closed.
(see Fig 8)
6.2 Tool selection
Successful wood turning does not result from high speeds, but
rather, from the correct use of turning tools.
A perfect and sharp wood turner tool is a precondition for
professional wood-turning.
Fig 7
Fig 8
Publicité
