Publicité
Les langues disponibles
Les langues disponibles
7.2 Installing work holding
Disconnect the machine from the power source (unplug).
The faceplate is used for tuning bowls. There are a number
of holes for mounting the workpiece.
Make sure the two sets screws (B, Fig 24) in the face plate
have been backed out.
Push in spindle lock (A)
Thread the faceplate onto the spindle in a clockwise direction,
and tighten.
Tighten the two set screws (B).
Remove the faceplate by loosening the two set screws (B).
Push in the spindle lock and use the provided tool (C).
Caution: always cut with your chisel on the left half of the
workpiece only.
Never press the spindle lock while the spindle is turning!
The spur centre is used to hold workpieces between centres.
Make sure the mating surfaces are clean.
Push the spur centre into the spindle.
Fig 24
Fig 25
To remove, use the knockout bar to tap out the spur centre.
Hold spur centre to prevent it from falling (Fig 26).
The live centre is used to hold a workpiece between centres.
Make sure the mating surfaces are clean.
Push the live centre into the quill.
To remove, rotate handwheel counter-clockwise to retract
quill, until centre releases from quill (Fig 27).
7.3 Adjusting tool rest
Position the tool rest (C, Fig 28) as close to the workpiece as
possible. Tighten handle (A) to lock.
Fig 26
Fig 27
Fig 28
Publicité
