Publicité
Les langues disponibles
Les langues disponibles
Test each set-up by revolving the work by hand to insure it
clears the tool rest and bed. Check setup at the lowest speed
before you increase to the operating speed.
Do not remove chips and workpiece parts until the machine is
at a standstill.
Never stop work pieces with the hand during run out.
Do not attempt to engage the spindle lock pin until the spindle
has stopped.
Never take measurements on a rotating workpiece.
Do not stand on the machine.
Connection and repair work on the electrical installation may
be carried out by a qualified electrician only.
Have a damaged or worn power cord replaced immediately.
Make all machine adjustments or maintenance with the
machine unplugged from the power source.
Make sure all levers and locking handles are tightened before
operating the lathe.
3.3 Remaining hazards
When using the machine according to regulations some
remaining hazards may still exist.
The rotating workpiece can cause injury.
Workpieces that are inhomogeneous or weak can explode
when being processed due to centrifugal force.
Only process selected woods without defects.
Unbalanced workpieces can be hazardous.
Injuries can occur when feeding tooling, if tool supports are
not correctly adjusted or if turning tools are blunt.
Risk of kickback. The tooling is caught by the rotating
workpiece and thrown back to the operator.
Thrown workpieces and workpiece parts can lead to injury.
Dust and noise can be health hazards. Be sure to wear
personal protection gear such as safety goggles and dust
mask. Use a suitable dust collection system. Work in a well-
ventilated area.
The use of incorrect mains supply or a damaged power cord
can lead to injuries caused by electricity.
4. Machine specifications
4.1 Machine description
1 Spindle handwheel
2 Index pin
3..Speed chart
4..Upper pulley cover
5 Headstock
6 Bed
7..Live centre
8 Tailstock
9 Tailstock handwheel
10 Motor
11..Belt tension lever
12 Lower pulley cover
13..Tool caddy / cord wrap
14 Face plate
15 Spur centre
16 Tool rest
17 Tool rest locking handle
18..Quill locking handle
19 Tailstock locking handle
21 On/Off switch
24 Tool rest base
25 Tool rest base locking handle
26 Belt tension release handle
Fig 1
Fig 2
Publicité
