Velleman ED91120 Notice D'emploi page 6

Installation
6.
P-1) Use the ceiling plate [1] to determine and indicate the position of the mounting
holes.
P-1A) When mounting on a brick or concrete ceiling, drill holes size Ø8mm and at
least 50mm deep at the indicated positions. Insert the included anchors
[15] and mount the ceiling plate [1] on the ceiling using the 3 included
screws [14].
P-1B) When mounting on a wooden ceiling or ceiling batten, drill holes size Ø3mm
and at least 50mm deep at the indicated positions. Make sure all the holes
are blind holes. Mount the ceiling plate [1] on the ceiling using the 3
included screws [14].
Slide the rubber gasket [6] over the ceiling plate [1].
P-2) Mount the projector arms [5] and projector plate [2] on the projector.
P-2A) Fix the projector arms [5] on the projector using the included bolts [17].
P-2B) There are 3 ways to use the spacers of the bolts [17], as indicated.
P-2C) Make sure the height of the 3 arms is equal.
P-2D) Turn the arms towards the centre and attach the projector plate [2]. Use
for each mounting point a spring washers [11], flat washers [16] and an
M6-screw [7]. Make sure all screws are secured tightly.
P-3) For Toshiba-type projectors, use following mounting instructions:
P-3A) Attach the included bracket adaptor #1 [9] to the projector using the M4-
screws [8].
P-3B) Fix the projector arms [5] on the bracket adaptor [9] and projector using
the included bolts [17] (see also P-2B and P-2C).
P-3C) Turn the arms towards the centre and attach the projector plate [2]. Use
for each mounting point a spring washers [11], flat washers [16] and an
M6-screw [7].
P-3D) Make sure all screws are secured tightly.
P-4) For Philips-type projectors, use following mounting instructions:
P-3A) Slide the included bracket adaptor #2 [10] into the projector housing.
P-3B) Fix the projector arms [5] on the bracket adaptor [10] and projector using
the included bolts [17] (see also P-2B and P-2C).
P-3C) Turn the arms towards the centre and attach the projector plate [2]. Use
for each mounting point a spring washers [11], flat washers [16] and an
M6-screw [7].
P-3D) Make sure all screws are secured tightly.
P-5) Mount an extension – 8cm [4] or 15cm [3] - to the ceiling plate [1] and connect
the projector plate [2] to the extension.
P-5A) Push on the two bolts of the ceiling plate (see arrows) and slide the desired
extension over the bolts until the bolts and the holes are lined up. Use the
4mm hex key [13] to turn the bolts counter clockwise to secure them.
P-5B) Push on the two bolts of the projector plate (see arrows) and slide it into
the extension until the bolts and the holes are lined up. Use the 4mm hex
key [13] to turn the bolts counter clockwise to secure them.
19/03/2009
WB020
6
©2008 Velleman ® Components nv