Victron energy Phoenix MultiPlus Compact 48/2000/25 Manuel page 16

The mains -input & output terminal connector can be found on the bottom of the Multi
Compact, see appendix 1. The shore or mains cable must be connected to the connector with
a three-wire cable. Use a three-wire cable with a flexible core and a cross section of 2.5 mm².
Procedure
Proceed as follows to connect the AC cables:
The AC input cable can be connected directly to the CAGE CLAMP® Wago connector.
The terminal points are indicated clearly. From left to right: "L1" (phase), "N" (neutral) and
earth.
The AC output cable can be connected directly to the CAGE CLAMP® Wago connector.
The terminal points are indicated clearly. From left to right: earth ,"L1" (phase), and "N"
(neutral).
3.6 Optional Connections
A number of optional connections are possible:
Undo the four screws at the front of the enclosure and remove the front panel.
3.6.1 Second Battery
The Phoenix Multi Compact / MultiPlus Compact has a connection (+) for charging a starter
battery. For connection see appendix 1
12