Publicité
EN
SAFETY INFORMATION
Failure to read these warnings may result in personal injury or vehicle damage.
Do not overload the locking jack stands beyond rated capacity. Overloading can cause damage to or failure of the jack stands. Position load on center of saddle
always using stands in pairs, on hard level surface capable of sustaining the load. Using stands on other than hard, level surfaces can result in instability and
possible loss of load.
OPERATION
1. Refer to your vehicle owner's manual for proper jacking lift point. This area of the vehicle is specified by the vehicle manufacturer.
2. Position stands under vehicle at points specified by vehicle manufacturer as proper load support points.
3. To adjust stands hold control lever up while lifting saddle shaft to desired height. Push control lever down to lock pawl into teeth located in center column.
Make sure pawl is fully engaged into teeth.
4. Carefully lower load onto stands. WARNING! Set both jack stands to the same height.
Fig. 1
MAINTENANCE
1. Visual inspection shall be made before using the stands. Check for cracked welds and missing and/or damaged parts. A stand that appears to be damaged
must me removed from service immediately.
2. Do not use jack stands as a long-term stand for the vehicle. Use them only while making repairs, then immediately lower vehicle to the ground.
SPECIFICATIONS
TECHNICAL DATA
Model
BWR5229
Capacity
2 Tons
Working Height
265 - 430 (mm)
Tab. 2
* The manufacturer reserves the right to make minor changes to the design and technical specifications of the products without prior notice, unless such changes significantly affect the performance and safety of
the products. The components described/illustrated on the pages of the manual you are holding in your hands may apply to other models in the manufacturer's product line with similar features and may not be
included in the product you have just purchased.
* To ensure the safety and reliability of the product and the validity of the warranty, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must be performed only by
technicians of the manufacturer's authorized service department.
* Always use the product with the supplied equipment. Operation of the product with non-supplied equipment may cause malfunctions or even serious injury or death. The manufacturer and importer are not
responsible for injuries and damages resulting from the use of non-compliant equipment.
2
BWR5023
BWR5123
3 Tons
6 Tons
275 - 415 (mm)
385 - 610 (mm)
WWW.NIKOLAOUTOOLS.GR
Saddle
1
2
Center Column
Pawl
3
4
Control Lever
Tab. 1
Locking Jack Stand
(2 pieces)
Fig. 2
Publicité
