HP Color LaserJet Enterprise M553 Guide D'installation page 8

8
Windows: Do not connect the USB cable until prompted during the software installation in the next step.
EN
Mac: Connect the USB cable now.
Windows : ne branchez pas le câble USB tant que vous n'y êtes pas invité durant l'installation du logiciel à l'étape suivante.
FR
Mac : connectez le câble USB maintenant.
Windows: No conecte el cable USB hasta que se le indique durante la instalación del software en el siguiente paso.
ES
Mac: Conecte ahora el cable USB.
Windows: Não conecte o cabo USB até que seja solicitado a fazê-lo durante a instalação do software na próxima etapa.
PT
Mac: Conecte o cabo USB agora.
9
EN Download or locate the driver software installation files
Method 1: Download from HP Easy Start (Windows and OS X)
1. Go to 123.hp.com/laserjet
2. Follow the onscreen instructions to download and launch the
installation file.
3. Follow the onscreen instructions to run the software
installation.
Method 2: Download from Product Support Web Site (Windows
and OS X)
1. Go to www.hp.com/support/colorljM553.
2. Select Software and Drivers.
3. Download the software for your printer model and operating
system.
4. Launch the installation file by clicking on the .exe or .zip file as
necessary.
Method 3: Install from the printer CD (Windows
Follow the on-screen instructions. See the Install Notes file
on the product CD for more specific software installation
instructions.
Method 4: IT managed setup (Windows only)
Visit hp.com/go/upd to download and install the HP Universal
Print Driver.
and click Download.
only)
NOTE: The default driver for OS X is the Apple AirPrint driver. To install the
full-featured HP driver for OS X, when adding a printer, from the drop-down
list of printers select the appropriate HP driver depending on the model.
For the product specific HP PCL.6 32 bit driver connecting with a USB
cable in Windows XP, and Windows Vista®:
Perform the following steps:
1. Make sure the product is turned on and connected to the computer.
2. Open the Windows Start menu, and then click Devices and Printers (or
Printers and Faxes for XP).
3. Right-click the name of this product, and select Printer Properties (or
Properties for XP).
4. Click the Device Settings tab.
5. Click the Installable Options section.
6. In the drop-down box next to Tray 3, select Installed.
7. In the drop-down box next to Printer Hard Disk, select Installed.
(Note: This setting applies even if an optional hard disk is not installed.
The product comes with an embedded multi-media controller instead
of a hard disk. An optional hard disk is also available.)
8. In the drop-down box next to Job Storage, select Automatic.
9. In the drop-down box next to Mopier Mode, select Enabled.
10. In the drop-down box next to Device Type, select Color.
7