Volpi OLYTECH mondial 755SP Manuel D'utilisation Et De Maintenance page 41

The electronic box shows the various functions of the machine through 3 Leds:
• ON - green Led: indicates that the electronic circuit is properly connected.
• MOTOR - yellow Led: indicates that the engine is properly connected to the electronic circuit.
• ALARM – Red Led:
fixed light means that the battery is off charge.
o
blinking light means that the battery voltage is becoming low.
o
if after charging the battery and having operated ON-OFF the main switch the red
o
light is still blinking, this requires the technical assistance provided in your territory.
In case of overloading, with excessive effort of the head among the branches, the motor stops
automatically in order to protect all the parts of the machine. In such case, remove the head from the
branches and after 1 second the machine restarts automatically.
After 5 consecutive times of locking of the head between the branches, with overloading, the machine
does not restart automatically and the red led fleshes. In such case, after having removed the head from
the branches, it is necessary to restart the machine with button Z.
If such a security system activates frequently, it means that the impact of the machine with the tree
branches is too violent and, therefore, it is necessary to use the harvester with more regularity.
If the machine does not start and the led on the handle flashes, it means that the battery output voltage
is below the minimum and so the battery must be recharged.
IMPORTANT: in the majority of cases, speed 1 is enough for olive harvesting so it is recommended. In
the few cases where more harvesting energy is temporarily needed, you can use speed 2 or 3. The use
of speed 1 allows a high energy saving and a longer battery operating time.
Do not connect the battery to the machine when it is not used.
Codes 855SP-L-XL 865SP-L-XL
The machine power supply is provided by a lithium battery 43,2Vcc – 11,6Ah (Codes 855Sp-L-XL) or
44Vcc 17,5Ah (Codes 865SP-L-XL) into the backpack. Thanks to a bipolar cable, it gives power to the
electronic board contained into the handle.
Since there isn't any supply voltage regulation system, the motor rotation speed is maximum when the
battery is charged and drops slightly while the battery is discharging; this situation is normal.
When the rotation speed of the tines drops too much, it is time to switch off the machine and recharge
the battery.
In case of overloading, with excessive effort of the head among the branches, the motor stops
automatically in order to protect all the parts of the machine. In such case, remove the head from the
branches and after 1 second the machine restarts automatically.
After 5 consecutive times of locking of the head between the branches, with overloading, the machine
does not restart automatically and the red led fleshes. In such case, after having removed the head from
the branches, it is necessary to restart the machine with button Z.
If such a security system activates frequently, it means that the impact of the machine with the tree
branches is too violent and, therefore, it is necessary to use the harvester with more regularity.
If the machine does not start and the led on the handle flashes, it means that the battery output voltage
is below the minimum and so the battery must be recharged.
IMPORTANT: in the majority of cases, speed 1 is enough for olive harvesting so it is recommended. In
the few cases where more harvesting energy is temporarily needed, you can use speed 2 or 3. The use
of speed 1 allows a high energy saving and a longer battery operating time.
Do not connect the battery to the machine when it is not used.
COMPANY WITH QUALITY SYSTEM
MANAGEMENT CERTIFIED BY ICIM
Tel. +39 0376 76009 Fax +39 0376 76408 www.volpioriginale.it
= ISO 9001 =
Davide e Luigi Volpi S.p.A.
Via San Rocco, 10 – 46040 Casalromano (MN) – Italia
41