Ocilion IPTV Technologies P510E IP Manuel D'utilisation page 52

Problem
Poor picture quality
Jerky picture
The brand of your TV set
is not in the code list or
brand list.
The TV set does not
respond even though the
automatic code search
was performed.
Table 3: Troubleshooting
In case of further issues, contact your network operator.
24 | P510E IP
Possible cause
Incorrect HDMI source
Incompatible HDMI cable Only use the supplied
The WiFi signal is too
weak.
Limited bandwidth due to
multiple users
The automatic code
search performs the
search on all codes.
This may take up to 15
minutes.
Remedy
Configure the HDMI
source of the TV set on
the set-top box.
high-speed HDMI
Go to setup and check the
signal strength under WiFi
status (see page 12).
Use the network cable
instead of WiFi.
Perform the automatic
code search (see section
"Automatic code search"
on page 19).
Perform the automatic
code search for at least
15 minutes.
cable.
®