Publicité
Les langues disponibles
Les langues disponibles
(1)
(2)
@)
(4)
(nM
volume
Connections
Remove the grid on the back of the amplifier (see picture
[8]). Then unscrew the cable strain relief clamp below
the power cord connection. After all cables have been
connected, reinstall the clamp and the grid.
Connecting the speaker
Depending on the system the speakers are connected as
follows: Also refer to page 7.
(For details refer to the separate speaker leaflet).
System | und [HI
rm
crs
Connecting the headphones
The headphones socket is located below the hinged
REVOX lid on the side above the amplifier [8D].
Connecting the antenna
On the bottom of the tuner (see photo [1 0A]) there is
a 75 ohm antenna socket. The supplied connector (see
photo [3B]) can be connected to an antenna cable and
plugged into this socket.
Power connection
Check that the voltage rating (230V) printed on the |
amplifier power inlet corresponds with your local line
voltage.
If necessary, the system can be converted to a different
line voltage by an authorized dealer.
Use only the fixed power cable (see photo [8A]) to
connect the system to the AC power source. In case of
difficulties please contact your local dealer.
When the equipment is switched off (standby), it is not
disconnected from the AC power source. The fact that
power is still available is indicated by the dimly glowing
symbol on the front of the amplifier. To completely
disconnect the equipment press the power switch (see
photo [8B]).
|
Publicité
