Sellstrom DP4 Instructions De Montage, D'utilisation Et D'entretien page 5

User's Guidelines
Thank you for choosing this Sellstrom Manufacturing Co., Inc. Personal Eye Protector. This personal
eye protector is in compliance with the European Directive 89/686/EEC and to the harmonized technical
standard EN 166.
PERSONAL PROTECTION EQUIPMENT
This product has been tested and approved in accordance to the following technical standards:
EN 166 & EN 170
Eye Protector
The use of eye protection and the standards they comply with are specified in the enclosed user's manual —
"proper marking of the protectors according to their use", considering its CE certification markings present
on the filter and on the frame. Storage, cleaning and maintenance: keep the protectors at normal temperature
in dry places. The filters shall be cleaned periodically. Always use warm water and soap to clean the lenses.
After washed, the protector shall be dried using a soft cloth. Daily check that physical conditions of the
protector are adequate. Scratched filters shall be replaced. Should filters require disinfecting, contact
Sellstrom Manufacturing Co., Inc. for advice. Wearers with an extremely delicate skin could develop allergic
reactions if they are in contact with the eye protectors materials (temples, nose pads, etc.)
Classification
Face screens: Mod. MP 4 CV (Clear Visor) provide protection against basic impacts, high speed particles
(B-120 m/s), resistance to surface damage by fine particles and are able to protect against optical radiation,
liquid droplets and short circuit electric arc.
Accessories: The oculars of some models are interchangeable but in order to maintain the safety of the eye
protector it is essential that the new oculars be the fit ones. Ask Sellstrom Manufacturing Co., Inc. for advice
about spare parts availability. Should you need to replace any of the eye protector's components, please
check the instructions supplied by Sellstrom Manufacturing Co., Inc..
Life of the product: Aging should not produce impairment on the eye protector if stored under perfect
conditions at a range of 5°–30° Celsius room temperature. However, if any impairment should be noticed, the
product shall be changed. The product should be changed after three years of normal use. If on the marking
is present a letter (F,B,A) followed by letter T, the faceshield protects the user against mechanical impact by
high speed particles at extreme temperature (from -5°C to +55°C), therefore if is not present the letter T, the
face shield protects the user against mechanical impact by high speed particles only at room temperature.
Packing: Always transport the product inside a case or a cover and never with tools or metallic objects.
Manufacturered by SELLSTROM MANUFACTURING CO., INC. A SureWerx Brand
Phone: 1 (847) 358-2000
Notified Body: Certottica S.c.a.r.l. (Notify Body number 0530), Z.Ind. Villanova, 1 — Longarone (BL) — ITALY
WARNING!
The scratched or damaged oculars should be replaced immediately. Don't use the visor with damaged
oculars, it could be cause injuries. The visor protects against high speed particles however wearing it over
standard ophtalmic spectacle may transmit impacts. Be careful wearing ophthalmic spectacles using the
visor too close to the face it maybe dangerous a cause of injuries.
Meaning of the MARKING
HOLDER MARKING The visor and the holder has the following marking code:
European Conformity symbol:
Manufacturer identification:
Field/s of use:
(if applicable — see table below).
Mechanical strength symbol
(if applicable — see table below)
CE
SM
---
---
INST-DP4