Sellstrom DP4 Instructions De Montage, D'utilisation Et D'entretien page 2

Window Removal and Replacement
Window Removal
1. Depress Release Tab using a hard object or finger,
while pulling down and out on the Window body.
When the Release Tab is depressed, the two
Locking Tabs should move out of locking position.
Window Assembly
1. Slide the Window UP and INTO the Crown at the corners,
so that the grooves in the Window fit into the notches on
the Crown.
2. Push the center of the Window UP and INTO the Crown. The
Locking Tabs should "snap" into place once properly secured.
The Release Tab will guide the window.
NOTE: Before using, make sure the Locking Tabs are fully engaged!
Flip Front Removal and Replacement
Flip Front Removal
1. Using a Phillips-head screwdriver, unscrew
the two screws that attach the Flip Front to
the Crown and Window.
RELEASE TAB
CROWN
WINDOW
CROWN
FLIP FRONT
WINDOW
PUSH PUSH
PULL PULL
CROWN
WINDOW
LOCKING TABS
REMOVE REMOVE