Sellstrom DP4 Instructions De Montage, D'utilisation Et D'entretien page 3

Flip Front Assembly
1. The Window must already be attached to the Crown before
proceeding to assemble the Flip Front. Please make sure
the Window is installed properly before continuing.
2. Insert the two screws through the interior holes of the
Window and Crown.
3. Place the Flip Front onto the exterior of the Crown,
matching the holes of the Flip Front to the protruding
screws from the interior.
4. Tighten the screws using a Phillips-head screwdriver until
secure. Do NOT over-tighten!
5. Check to assure the Flip Front operates smoothly
without interference.
For your own protection, read these instructions before using. It is the responsibility of the user to
understand the limitations, proper use, care and maintenance of the product. Failure to read these
instructions could result in serious injury, including blindness.
1. Check with supervisor or employer before using to determine whether this product is suitable for your
job and in your area.
2. Impact resistant shields are NOT unbreakable and DO NOT provide extraordinary protection against
flying particles, splash, spray, and spatter. They will not provide protection against severe impact
hazard, such as, but not limited to, fragmenting grinding wheels, high speed projectiles, explosive
devices or molten metal.
3. Pitted or scratched plates reduce vision clarity, SEVERELY REDUCE IMPACT PROTECTION, and
should be replaced immediately to prevent injury.
4. This product is NOT suitable for protection against x-rays, gamma rays, high energy particulate
radiation, lasers, and/or masers.
5. Inspect the faceshield Window frequently and immediately replace worn, pitted, or scratched Window.
6. If used with CLEAR Window, this Window will NOT provide any protection against ultraviolet or
infrared radiation.
7. If used with SHADED Window, DO NOT USE FOR ARC WELDING!
8. This product does NOT conform to ANSI Z87.1 for welding helmets.
9. Flip Front CANNOT be used with shaded Window. The only configurations allowed are:
• Clear Window with Shade 5 Flip Front
• Clear Window with Shade 6 Flip Front
• Clear Window with Shade 8 Flip Front
• Clear Window with NO Flip Front
• Shade 3 Window with NO Flip Front
• Shade 5 Window with NO Flip Front
10. A Window must be used at all times. Do NOT use a Flip Front without a Window.
11. Product needs to be used only with appropriate Window and Flip Front.
12. When using a configuration with no Flip Front, use Crown without holes.
WARNING!
INST-DP4
ATTACH ATTACH