Dometic T2500 H Instructions De Montage Et De Service page 10

IMPORTANT
When mounting a new spark plug, tighten it a half-turn after
it has compressed the washer. When re-using the same
spark plug, tighten it 1/8-1/4 turn after the washer
compression.
CAUTION
The spark plug should be tightened carefully. A loose spark
plug can get very hot and damage the engine.
5.3.4 REGULATING THE VOLTAGE
This regulation should be carried out with the engine warm
and the generator running without a load.
Check the generator voltage using a tester or voltmeter
connected to the vehicle's 230V socket or to the terminals
(pos. 17-18 fig. 6 and 14) of the generator terminal board.
The voltage should be between 230 and 240 Volts.
If these values are not obtained, adjust the current regulation
screw (pos. 32 fig. 10 and 15) until they are.
Rotate clockwise to increase the voltage.
Rotate anticlockwise to decrease both r.p.m. und voltage.
6.00 INACTIVITY AND DISMANTLING
6.01 DISMANTLING
If the unit must be dismantled, get the work done by
authorised workshops.
7.0 DEALING WITH FIRE HAZARDS
In case of fire, do not open the generator casing and use
type-approved fire-extinguishers.
8