Agilent Technologies Turbo-V 701 Notice De Mode D'emploi page 230

17 Technical Information
Serial Communication (J2 Connector)
Stop Speed Reading
This function allows the user to read the pump rotational frequency
(window 232) even after a stop command, during the braking. The
function can be activated/deactivated by serial communication
(WIN 167). If activated, all the related functions (set point output,
programmable analog output – if related to the frequency, ...) will
follow the frequency reading.
The T-Plus Software (optional) allows the operator to set all the programmable
NOTE
feature.
Serial Communication (J2 Connector)
Figure 20
This is a 9 pin Female D-type serial input/output connector to control
via an RS 232 or RS 485 connection the Turbo-701 Pumping System.
Tab. 4
PIN N.
1
2
3
4
5
6
7
8
9
230/288
SIGNAL
+5Vdc OUT (100mA max)
TX (RS232)
RX (RS232)
Not connected
GND
A + (RS485)
Not connected
B – (RS485)
Not connected
Turbo-V 701 Rack Controller User Manual / 87-901-032-01