Publicité
Les langues disponibles
Les langues disponibles
Safety in use
•
Always remove the plug from the device when it needs to be maintained or cleaned.
•
Never use the device in the vicinity of hot or hot objects.
•
Prevent the device from coming into contact with rain.
•
Do not place other electrical devices in the device.
•
Do not place chemical or explosive agents in the device.
•
Only use the DC 12V/24V (2,5; 16AWG) or 230V connection cable (230V not included). NOTE: never use both
energy sources at the same time.
•
Defrost the device regularly to ensure that the device functions optimally.
•
Do not pull on the connecting cord, but pull on the plug to remove the cord from the socket.
•
If the cool box is connected to the DC socket, disconnect your cool box and other consumers from the battery
before you connect a fast charger
•
If the cool box is connected to the DC socket; switch off the cool box or break the connection when you switch
off the engine. The battery can be discharged otherwise.
•
Pay attention! That the heat that arises during the operation of the cool box can be properly dissipated.
•
Enough distance between product and objects and walls.
•
Never immerse the device in water
•
Ventilation slots must not be covered at all times.
Use
•
Remove all packaging materials from the device.
•
Place the device on a flat and stable surface with at least 10 cm of free space on each side.
•
Do not switch the appliance on immediately after you transport it, where the cool box has been tilted more
than -30 °. This could cause damage to the cooling system. The device must first stand upright for 30 minutes
so that the coolant can be collected again in the compressor. This prevents the compressor from running dry.
•
Look at the above safety instructions before use.
•
For hygienic reasons, you must clean the inside and outside of the appliance with a damp cloth before using
your cool box.
•
Connect the cooler box.
Control
1.
Switching on and off: press and hold the on / off button, the refrigerator will now start or switches off.
2.
Temperature adjustment: press the "
3.
Fast cooling / energy saving mode: press the set button "
and energy saving mode ECO.
4.
Switch C to F : In standby mode, hold down the "
Celsius, (F is Fahrenheit, C is Celsius), Then use the "
5.
Battery protection: In standby state, press "
protection gear setting menu, and then press "
" or "
" button to adjust the temperature. The temperature is now set.
" to quickly switch between cooling mode MAX
" and "
" or "
" to select Celsius or Fahrenheit.
" and "
" for 3 seconds at the same time to enter the battery
" or "
" to set the corresponding battery protection.
" key for 3 seconds to switch Fahrenheit and
ENGLISH
Publicité
