Running A Program - afx light W-DMX192 Manuel D'utilisation

CHASE review
1.
Select a CHASE button (1-6) to review
2.
Press the TAP DISPLAY button to view the step number on the display
3.
Press the BANK UP/DOWN buttons to review all scenes in the chase
Note: Make sure you are still in MANUAL mode
Programming
A program (bank) is a sequence of different scenes (or steps) that will be called up one
after another. In the FIXTURE, 30 programs can be created with 8 scenes in each.
To enter in program mode, hold the program button during 3s
Create a scene
A scene is a static lighting state . Scenes are stored in banks. There are 30 bank memories on the
controller and each bank can hold 8 scene memories. The FIXTURE can save 240 scenes total.

Press and hold the PROGRAM button until the LED blinks.

Position SPEED and FADE TIME sliders all the way down.

Select FIXTURE(S) to begin adjusting the DMX values

Move faders to adjust parameters to the required setting for the fixture(s)

De-select a fixture to hold its DMX values

Adjust for all fixtures until all are set at the required state

Press the MIDI/ADD button

Select a BANK and then select a SCENE to store the scene

Press PROGRAM to store

Repeat the above process for up to 8 scenes in the bank

Hold the PROGRAM button to exit Program mode
Notes:
Deselect BLACKOUT if LED is lit.
Toggle the PAGE SELECT button to access channels 9-16 All LEDs flash to confirm storing a scene
S h o rtc ut: P ress [P R O G R A M ] [F IX T U R E S ] A d jus t [F a d e rs ] [B A N K ] [S C E N E ]
P ress [P R O G R A M ] to s to re .

Running a program

1.
Use BANK UP/DOWN buttons to change Program banks if necessary
2.
Press the AUTO DEL button repeatedly until the AUTO LED turns on
3.
Adjust the program speed via the SPEED fader and the loop rate via the FADE TIME fader.
4.
Alternatively you can tap the TAP DISPLAY button twice.
The time between two taps sets the time between SCENES (up to 10 minutes)
Note: Deselect Blackout if LED is lit.
Check a program
1. Press and hold the PROGRAM button until the LED blinks
2. Use BANK UP/DOWN buttons to change Program bank to review
3. Press the SCENES buttons to review each scene individually