Operating; Manual Mode - afx light W-DMX192 Manuel D'utilisation

OPERATING

Activation of wireless DMX tranmistter
-Press the WIFI selector to activate the transmitter (the led lights). The DMX channel display lights.
-Use the small ID button (located to the right of the display wireless DMX channel) to select the
transmission channel of the DMX wireless (from 0 to 9 then A to F so all 16 channels)
-The TXD led is lit which means that the console transmits the DMX signal
Use these receptors DMX wireless compatible such as the W100DMX, the W500DMX or the stand
alone PARLED-W3 and PARLED-W12 leds projectors.
When only the console and a compatible receiver to work together, the TXD led will blink quickly
To disable the wireless transmitter, press once again on the WIFI button (the led goes off)
Fader time assign
You can choose whether the board's fade time during scene execution is implemented
broadly to all output channels or only to the Pan & Tilt movement channels. This is relevant
because often you will want gobos and colors to change quickly while not affecting the
movement of the light.
1.
Turn the FIXTURE power OFF
2.
Hold the MODE and TAP DISPLAY buttons simultaneously and switch the power back ON
3.
The FIXTURE is now in Fade Time Assign mode
4.
Pressing the TAP DISPLAY button toggles between "ALL CH" and "ONLY X/Y"
5.
ALL CH means that fade time affects all channels
6.
ONLY X/Y means that fade time only affects pan and tilt functions

Manual mode

The manual mode allows a direct control of all the DMX device. For that, user faders
1. Select a FIXTURE button
2. Press the AUTO DEL button repeatedly until the MANUAL LED is lit.
3. Move the faders to change parameters for the selected fixture(s)
PAGE/SELECT A/B button: Use to switch between fader control pages
TAP DISPLAY button: Press to toggle the output indicator on the LCD display between DMX
Note: All changes made within MANUAL mode will be temporary and will not be recorded
Review scene or chase
This instruction assumes that you have already recorded scenes and chases on the controller. Otherwise
skip this section and go to programming.
SCENE review
1.
Select a SCENE button (1-8) to review
2.
Select any one of the 30 banks by pressing the BANK UP/DOWN buttons
3.
Move faders to change fixture attributes Action
values (0-255) and percentage (0-100)
(A: Ch1~8), (B: Ch 9~16)