Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
1. Use a small paper clip to free any foreign material clogging or restricting the spray tip.
2. Using a garden hose, flush debris out of spray tip by back flushing (running the water through
the spray tip backward or from the outside to the inside).
3. Reinstall the spray tip to the spray wand.
RECOMMENDED PUMP CARE
•
Regularly using pump protector solution (not included) can help extend the lifespan of the product. It
aids in the removal of hard water mineral deposits, lubricates pump seals and pistons, and prevents
freeze damage.
•
To maintain the best performance of the product, pump protector should be added to the product after
every use and before long-term storage.
Note: The following steps are typical for adding pump protector to the product. Always read the
specific instructions provided by the manufacturer of the pump protector used before starting.
1. Turn the water tap off and make sure the product is powered off.
2. Press the spray gun trigger for approximately 1 minute or until no more water discharges from
the connected accessory.
3. Disconnect the power cord from the outlet.
4. Disconnect the hose from the water inlet.
5. Remove the cap from pump protector bottle and insert the pump protector spout into the water inlet.
6. Turn the water inlet sleeve to secure the connection.
7. Squeeze the pump protector bottle to inject protector fluid into the product.
8. The procedure is complete when the protector fluid discharges from the water outlet.
19
Publicité
