De Dietrich DHG7501X Instructions D'utilisation Et Avis De Montage page 13

or with another device ensuring
omnipolar disconnections from
the grid, with an opening distance
between the contacts of at least 3
mm, then such disconnecting de-
vices must be supplied within the
fixed installation.
If the fixed appliance is endowed
with a supply cord and a plug, the
appliance has to be put in a place
where the plug can be reached
easily.
* The use of materials which
can burst into flames should
be avoided in close proximity
of the appliance. When frying,
please pay particular attention
to fire risk due to oil grease.
Being highly inflammable, fri-
ed oil is especially dangerous.
Do not use uncovered electric
grills. In order to avoid possi-
ble fire risk, all instructions for
grase-filter cleaning and for re-
moving eventual grease depo-
sits should be strictly followed.
USES
The appliance is already arranged both for filtering
and for suction performances.
* In its filtering version (Fig.1), the air and fumes
conveyed by the appliance are depured both by
a grease filter and by an active coal filter, and put
again into circulation through the hole made on
the top of the cabinet.
* In its sucking version (Fig.2), fumes are direct-
ly conveyed outside, through an evacuation duct
connected with the superior part of the wall or the
ceiling. Both coal filter and air deflector are not ne-
cessary in this case.
INSTALLATION
Before installing the appliance, make sure that
none of the parts is damaged in any way. In case
of damaged parts, contact your retailer and do not
proceed with installation.
Read all of the following instructions with care be-
fore installing the appliance.
- Use an air outlet pipe of the shortest possible
length.
- Limit the number of pipe bends.
- Use a material approved by standards and re-
gulations.
- Avoid any sudden changes in pipe section (re-
commended constant diameter: 150 mm or equal
surface area).
* Before installing the appliance, in order not to
damage the appliance itself, the metal grase filter
should be removed. Such filter can be removed by
pushing the special filter handle toward the back
side of the cooker hood and turning it downwards
so to unfasten it from its slot (Fig.3).
Essential precautions to respect before installing
the appliance are the following:
To have made a cut-out on the bottom of the ca-
binet which is suitable to hold the appliance in po-
sition (fig.4).
* prepare the power supply.
* prepare a hole for the exhaust of the air both in
the filtering and in the exhauting version.
To install the appliance, adjust the position of the
stop side-springs using the appropriate screws
(fig.5), according to the thickness of the board
previously drilled, on which the appliance will be
fixed.
Insert the built-in unit in the hole made in the cabi-
net until the stop click of the side- springs is heard
and the built-in unit is blocked.
Insert the screws provided in the holes inside the
appliance (fig.6) to block it completely.
Blocking of the stop valve
Warning!
Before connecting the flexible exhausting pipe to
the motor, make sure the stop valve, which is on
the air outlet of the motor, can swing.
13