Auping AVS 433 Mode D'emploi page 25

fig. 3
4.5 Relocating operating side of
adjustment cord
The adjustment cord for your mesh
base is on the right, but it can easily be
moved to the left.
1. Untie the knot A from the cord B and
remove the ball C (see fig. 4).
2. Remove the protective tube D from
the cord guide E and slide the tube
off the cord (see fig. 5).
3. Tie a knot in the end of the cord.
_03QVU_4459 BW.pdf - pag.23
4. Pull on the cord at the other side of
the mesh base.
5. Untie the knot.
6. Pull the cord through the protective
tube (first through the eye, then
through the tube).
7. Hook and pull the protective tube
over the cord guide.
8. Push the cord through the smaller
hole in the ball.
9. Tie a knot in the end of the cord.
10.Pull the control ball over the knot.
fig. 4
fig. 5
LET OP !!! Lage resolutie!
GB23
November 17, 2009