Publicité
•
Warning •
Avvertenze
EN_IMPORTANT, RETAIN FOR FUTURE
REFERNCE: READ CAREFULLY.
• Check the box contents.
• To avoid damaging the cot during
assembly, please remove all the
packaging materials on a clean, flat
surface.
• ATTENTION!
performed by an adult only.
• IMPORTANT: To assemble the cot
correctly, carry out the assembly
operations in the indicated order.
Incorrect assembly operations could
make the cot unsafe.
• WARNING: Be aware of the risk of
open fire and other sources of strong
heat, such as electric bar fires, gas
fires, etc. in the near vicinity of the
cot.
• WARNING! Do not use the cot if any
part is broken, torn or missing and
use only spare parts approved by the
manufacturer.
• WARNING! Do not leave anything
in the cot or place the cot close to
another product, which could provide
a foothold or present a danger of
suffocation or strangulation, e.g.
strings, blind/curtain cords, etc..
• WARNING! Do not place more than
one mattress in the cot.
• The product is ready for use only when
all locking mechanisms are engaged.
Make sure they are securely engaged
before use.
• Remove the base support (v) and hook
(z) when the base is in the lowest
position.
• The lowest position is the safest and
that the base should always be used
in that position as soon as the baby is
old enough to sit up.
• If you leave the child unattended in
the cot, always make sure that the
movable side is closed.
• Important
when
mattress; There has to be at least a
Avvertissement •
Assembly
must
choosing
Advertências •
500 mm distance between the upper
surface of the mattress and the upper
border of the bed sides (highest
position in case of adjustable bedside
heights) when the cot base is fixed in
be
its lowest position. There has to be at
least a 200 mm distance between the
upper surface of the mattress and the
upper border of the bed sides (highest
position in case of adjustable bedside
heights) when the cot base is fixed in
its highest position.
• This cot requires a 124x63 cm mattress.
Maximum mattress thickness: 12 cm.
• The dimension shall take into account
that there shall be no gap more than
30 mm between the mattress and the
sides end ends in any position of the
mattress.
• Periodically check that the screws
are tightened correctly. Should any
screws be loose, tighten them to avoid
the risk that any object (necklaces,
clothes, etc.) could remain entangled
and pose a risk of strangulation.
• In order to prevent falls, when baby
can climb out of the cot, stop using
the cot itself.
• Use only spare parts supplied or
authorized by the manufacturer.
• Correct use and maintenance will
make the cot durable and safe over
time.
• Clean with a damp cloth or neutral
detergent (NO SOLVENTS) and allow
to dry in the air.
cot
Advertencias •
Προειδοποιήσεις
Publicité
