Publicité
Les langues disponibles
Les langues disponibles
SERVICE AND ADJUSTMENTS
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 30)
The throttle control has been preset at the factory and
ad just ment should not be necessary. If adjustment is
necessary, proceed as follows:
•
With engine not running, move remote throttle control
lever to "FAST" position.
•
If throttle lever on engine touches high speed stop, no
further adjustment is necessary. If throttle lever does
not touch high speed stop, continue with adjustment
procedure.
•
Loosen cable clamp screw.
•
Move throttle lever up until it touches high speed stop,
and hold in this position.
•
Tighten cable clamp screw securely.
CASING AND WIRE
CLAMP SCREW
THROTTLE
CONTROL
Fig. 30
TO AD JUST CARBURETOR
The carburetor has been preset at the factory and cannot
be adjusted.
IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR,
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.
OVER SPEED ING THE ENGINE ABOVE THE FACTORY HIGH
SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,
CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER/
DEPARTMENT, WHICH HAS THE PROPER EQUIP MENT AND
EXPERIENCE TO MAKE ANY NEC ES SARY ADJUSTMENTS.
18
Publicité
