Skil HD529401 Guide D'utilisation page 16

LED Worklight (Fig . 8)
Fig. 8
Your tool is equipped with an LED worklight,
located on the base of the tool, that illuminates
when the variable-speed trigger switch is
squeezed. This provides additional light on the
surface of the workpiece for operation in lower-
light areas.
The LED worklight will automatically turn on
with a slight squeeze on the variable-speed
trigger switch before the tool starts running,
and will turn off approximately 10 seconds after
the variable-speed trigger switch is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
LED worklight
are overloaded, the LED worklight will rapidly
flash. Rest the tool for a while or place the tool
and battery pack separately under flowing air to cool them.
The LED worklight will flash more slowly to indicate that the battery pack is at low-battery
capacity. Recharge the battery pack.
16