practyl 12SD1-25T.1A Instructions D'origine page 93

TROUBLE SHOOTING
PROBLEM
PRODUCT DOES NOT START
THE MACHINE STOPS WORKING
AFTER ROTATING SLOWLY
UNUSUAL VIBRATION DURING USE
SPARKING VISIBLE THROUGH THE
HOUSING AIR VENTS
UNSATISFACTORY RESULT
STORAGE AND TRANSPORTATION CONDITION
The tool must be stored in a dry, heated room at a temperature of 0 to +40 °C. The instrument is transported in
closed vehicles in accordance with the rules for the carriage of goods in force on this type of transport. During
transportation and handling operations, the packaging with the product should not be subjected to sharp impacts
and the effects of precipitation. After transporting the tool in winter conditions, it is necessary to keep it at room
temperature for at least 2 hours until the moisture is completely dry.
PROTECT OUR ENVIRONMENT
CAUTION! This product has been marked with a symbol relating to removing electric and electronic waste. This
means that this product shall not be discarded with household waste but that it shall be returned to a collection
system which conforms to the European WEEE Directive. Contact your local authorities or stocks for advice on
recycling. It will then be recycled or dismantled in order to reduce the impact on the environment. Electric and
electronic equipment can be hazardous for the environment and for human health since they contain hazardous
substances.
POSSIBLE CAUSE
Not connected to power supply
Other electrical defect to the
product
The battery is low power
Air vents are blocked
The battery is low power
Bit is not well assembled
A small amount of sparking may be
visible through the housing vents
Drill bit is worn or not adapted to
the material to drill
SOLUTION
Connect to power supply
Check by a specialist electrician
Need to charge the battery pack
before operating
Clean the air vents
Need to charge the battery pack
before operating
Disassembly and assembly
the blade by strictly following
instructions
This is normal and does not
indicate a problem
Replace with new bit or check the
compatibility between drill bit and
material to drill
EN - 93